 |
| This collar and bearing required a LOT of force to remove. (Hydraulic press). |
 |
| Welded a washer onto the race and used a press. |
 |
| Most bearings & seals came out with an arbor press and various sizes of round bar. |
 |
| Welded a piece of flat bar into the outer race and pressed out from other side. |
 |
| Used a puller to remove the needle bearing outer race. There is also a small hole in the back side of the casting and you might be able to use a punch to get this one out instead of a puller. |
No comments:
Post a Comment